Results 1 to 1 of 1

Thread: Has anyone disassembled a Chrysler LXI steering column before?

  1. #1
    Senior Member MacGyver's Avatar
    Join Date
    Dec 2004
    Posts
    3,047

    Has anyone disassembled a Chrysler LXI steering column before?

    Here is my issue.

    A while back I picked up a Chrysler LXI steering column to use in my build. It was necessary for me to fully collapse the shaft in order for it to fit properly in my Fiero chassis. Now that I have it all mounted I discovered that I have some play in it. I’m assuming since I collapsed the shaft there is play between the two segments of the collapable shafts. Has anyone attempted to remove the shaft assembly from the column so it could be tightened up or welded?

    Not sure what to do about this. It’s not a whole lot of play but it will probably be annoying once I get the car on the road.
    Last edited by MacGyver; 08-25-2012 at 04:35 PM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •