Results 1 to 3 of 3

Thread: AD 355 build question aligning body panels

  1. #1

    AD 355 build question aligning body panels

    I have the body panels on the car, but am stuck aligning them. The doors align to the rear clip. But, the doors to the fender does not align to well. I have the fenders trimmed down so that the doors open, but the gap is 1/4". John says that it should be 1/8".

    Does anyone have a magic on how to align the doors to the fender?

    Show us your lower fender brackets also.

  2. #2

    Re: AD 355 build question aligning body panels

    call me 706 971 4676 did you remove 1 inch squire plastic at front door edge

  3. #3

    Re: AD 355 build question aligning body panels

    I did remove the 1" square near the front of the door. (that only took me two hours to figure out)

Similar Threads

  1. Question about fiberglass panels (how much to use for a panel)
    By blackpass in forum Technical Discussion & Question
    Replies: 1
    Last Post: 01-12-2011, 10:11 AM
  2. Thickness of body panels
    By muttled in forum Technical Discussion & Question
    Replies: 3
    Last Post: 09-19-2007, 08:45 AM
  3. 512 body panels
    By mike dd. in forum The Mall
    Replies: 96
    Last Post: 03-13-2006, 12:31 AM
  4. Best plastic for body panels?
    By G-Nasty in forum Technical Discussion & Question
    Replies: 2
    Last Post: 11-15-2003, 10:26 PM
  5. TR BODY PANELS
    By mike d. in forum The Mall
    Replies: 3
    Last Post: 03-20-2003, 10:20 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •