Announcement

Collapse
No announcement yet.

Another reason not to buy from tony sousa!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • MadMechanic
    replied
    Re: Another reason not to buy from tony sousa!

    DKOV sumed it up quite nicely

    Leave a comment:


  • Guest's Avatar
    Guest replied
    Re: Another reason not to buy from tony sousa!

    I think the point is that the car was "represented" to have been in good working condition. Things like this rust pool were "implied" to be NOT present.

    There IS a difference between a $5000 Fiero and a $400 fiero. Apparently, the RUST is the difference!

    Of course, Ari, if you plan on doing a Held a-arm swap to get the proper track width, much of that will go away in the replacement. New poly should go on anyway...

    Not that it makes it OK, it's just a way back to safety

    DKOV -

    Leave a comment:


  • derwin
    replied
    Re: Another reason not to buy from tony sousa!

    You are not the only person to purchase a 15 year old
    Fiero and find rust .. a guy down south has the same
    experience .. Honestly did you expect him to replace
    all the parts and provide you with a new Fiero? I think
    not .. its not pretty but you have to expect some
    crap in a 15 year old car .. its part of the Kit Car build
    to replace rubber, brake lines, brakes, calipers, etc.

    Been there done that...

    Leave a comment:


  • MadMechanic
    replied
    Re: Another reason not to buy from tony sousa!

    Actually the engine started right up (after I replaced the battery cables which had corroded away)... It did (And still does) Idle at 2800rpm though (havent had time to check the vacum tubes yet)

    Leave a comment:


  • Guest's Avatar
    Guest replied
    Re: Another reason not to buy from tony sousa!

    Did this thing RUN when you got it?

    What a mess!!!

    DKOV -

    Leave a comment:


  • William
    replied
    Re: Another reason not to buy from tony sousa!

    Hopefully the rust hasn't penetrated though the frame if it's just on the exterior then sanding priming and painting is all you would have to do. Time comsuming but not to hard.
    Looks like you need a new boot for you CV axle.

    Leave a comment:


  • MadMechanic
    replied
    Re: Another reason not to buy from tony sousa!

    I'm now looking at over a thousand dollars of rust repairs alone! AHHH!

    Leave a comment:


  • Guest's Avatar
    Guest replied
    Re: Another reason not to buy from tony sousa!

    Ugly man... just plain ugly.

    DKOV -

    Leave a comment:


  • MadMechanic
    started a topic Another reason not to buy from tony sousa!

    Another reason not to buy from tony sousa!

Unconfigured Ad Widget

Collapse
Working...
X